Systec DB-45 - Error Message: Water Pump Error; Error Message: no Chamb Water

V/D S ERIES
T ROUBLESHOOTING
Revision: 2.1 7-7
7.3.4 Error message: Water pump error
Error message: Water pump error
No water detected at the high electrode
of the generator after approx. 2 minutes
(
parameter 70, “GenWtrErrT”)
- Defective electrode
- Check the steam generator
(
see chapter 3.8.1, “Steam generator”)
7.3.5 Error message: No chamb water
Error message: No chamb water
No water has been measured at the water
level electrode (E3) of the sterilisation
chamber approx. 5 minutes
(
parameter 94, “WtrChambErr”)
after the program starts
- Check function and cleanliness of
water inlet valve
- Check and clean the strainer
- Check the water level electrode