V/D
S
ERIES
R
EGULAR TESTS AND MAINTENANCE
5-2 Revision: 2.1
Diagrams
Fig. 1: Calibration: Navigating to the Service menu item ................... 10
Fig. 2: Calibration: Navigating to the Calibration menu item .............. 10
Fig. 3: Calibration: Entering the service code .................................... 11
Fig. 4: Calibration: Selecting a parameter .......................................... 11
Fig. 5: Calibration: Selecting the calibration type for gain and
offset values ............................................................................ 12
Fig. 6: Calibration: Manual entry of the gain and offset values .......... 13
Fig. 7: Calibration: Calculation of the gain and offset values
using the high and low values from a reference
measurement produced with external test equipment............. 14
Fig. 8: Calibration: Restoring the last saved gain and offset values ... 15
Tables
Tab. 1: Maintenance tasks on the control unit .................................... 4
Tab. 2: Maintenance tasks on the door lock ....................................... 4
Tab. 3: Maintenance tasks on the pressure chamber,
hose connections and filter ..................................................... 4
Tab. 4: Maintenance tasks on the steam generator ............................ 5
Tab. 5: Other maintenance tasks ........................................................ 5
Tab. 6: Maintenance tasks for the test run and calibration.................. 5
Tab. 7: Maintenance tasks for the water supply .................................. 5
Tab. 8: Maintenance work for water cooling ....................................... 6
Tab. 9: Maintenance work on the radial fan ........................................ 6
Tab. 10: Maintenance work for spray cooling ....................................... 6
Tab. 11: Maintenance work on the closed cooling circuit ...................... 6
Tab. 12: Maintenance work on the lift ................................................... 7
Tab. 13: Maintenance work on vacuum unit ......................................... 7
Tab. 14: Maintenance work on the exhaust filter .................................. 7
Tab. 15: Maintenance tasks on the printer ............................................ 8
To Next Page
Loading...
