Precaution for stora
e
・Do not use if the unit package or the product has been
damaged or soiled. Use it immediately after opening the
unit package and dispose of it safely after use.
・Spare pack of CAPIOX EBS Circuit should be available for
emergency exchange.
・Do not allow solvents such as alcohol, ether, acetone, etc.
to come in contact with the device as it may cause
damage to the device.
・ Use CAPIOX SP Pump Console SP-101 and CAPIOX
Centrifugal Pump Controller SP-200 according to the
instructions described in the Instructions for Use.
・Set this product correctly with a holder or a drive motor.
・The centrifugal pump of this product contains a magnet.
Therefore, keep away from metals and magnetic tapes.
・ Use this product at flow rate lower than the maximum 7
L/min.
・Do not exceed the maximum pump speed of 3000rpm.
Otherwise, it would increase blood damage and cause
breakage of this product and leakage.
・ Do not install or remove the pump until the motor has
completely stopped.
・All procedures must be aseptically performed.
・Perform priming procedure using crystalloid solution which
contains no blood, plasma and/or blood derived products.
・For monitoring temperature, Y.S.I. 400 Series manufactured
by Measurement Specialties Inc. can be used. Use it with
its exclusive cable.
•
In case of using CAPIOX EBS Cannula Kit, follow
instructions described in the Instructions for Use.
・
Water pressure at the heat exchanger inlet should
not exceed 196kPa (2kgf/cm
2
). Pressure greater than
196kPa
(2kgf/cm
2
) may cause leaks or damage to the device.
・
Pay attention not to wet the device. Avoid direct sunlight,
extreme temperature and humidity for storage.
PRECAUTION
To Next Page
Loading...
Need help?
General
