Other Operation Procedures
Network equipment
(Server)
recv( )
Controller
(Client)
disconnect( )
The flow when the communication is disconnected is shown below.
FIN
Unconnected
(close)
CDI Communication
The flow information can be transmitted to the CDI System 500.
Before the power is turned on, connect the CDI port of the Controller to the pump interface terminal of the CDI System 500 with the
CDI Communication Cable, and turn the setting of the CDI communication function of the Controller on. For details about how to
set, refer to “Setting the Communication with CDI” (page 116).
• For details about how to use the CDI System 500, refer to the instructions for use of the CDI System 500.
82
Note
To Next Page
Loading...
