Terumo CAPIOX EBS Circuit with X coating - Pre-Circulation Inspections and Start

Operation Procedure
Use the
temperature
measuring
fun
YES
YES
Use the pressure
measurin
g
function
Fill Priming Solution
Preparing Circulation
The preparation steps for circulation are shown below.

page 43

page 43

page 44

page 46

page 47

page 48

page 49

page 46

page 46

page 125

page 50

page 51
Continue to “Starting
Circulation”

page 55
42
YES
Use the pressure
measurin
g
function
YES
Use the Fast
Clam
p
Inspection Before Circulation
Starts (Before Each Use)
Auto-priming
Confirm the Setup
Turn the Power On
Attach the ABD/Flow Sensor
Attach the Centrifugal Pump to
the Drive Motor
Centrifugal Pump Connection
to the Tube Pack
c
tion
NO
Attach the Temperature Sensor
(CAPIOX Luer Thermistor)
NO
Attach the Pressure Sensor
NO
Calibration of the Pressure Sensor
NO
Attach the Fast Clamp