Examples of disinfectants (ingredient names) which can be used are listed below.
Examples of Cleaning Disinfectants (Ingredient Names)
Ingredient Name Dilution (e.g.)
Chlorhexidine gluconate 5%
Benzalkonium chloride 10%
When using a disinfectant solution, refer to instructions for use (Regarding dilute concentration, etc.) of each disinfectant solution.
If you have any questions, contact Terumo
ʼs
service representative.
Clean immediately with a damp (not wet) soft cloth.
When cleaning the ABD/Flow Sensor, use a soft cloth soaked in water or lukewarm
water and squeezed well to wipe off the vaseline applied to the detection window
(Figure 4-1) of the ABD/Flow Sensor.
Figure 4-1
Storage
Ensure that the battery is charged in preparation for the next use.
Store the system in a location where it is not exposed to moisture, sunlight, high temperature, or high humidity.
Storage conditions: Ambient temperature -20 to 45 °C, relative humidity 10 to 95% RH (non-condensing)
121
After Use
Cleaning Method
• Do not expose this system to direct sunlight or ultraviolet irradiation for a long period of time. The exterior may experience
colour change, deformation or deterioration.
• Do not store this system in a place with a high level of vibration, dust, mist or corrosive gas.
• Do not store this system in a place where an environment of atmospheric pressure, temperature, humidity, ventilation, or
corrosive conditions may cause an adverse effect.
• Do not store this system in a storage area for chemicals or in a place where gases are generated.
• Do not store this system under high temperature and high humidity.
• Do not store the battery in a discharge status. Storing the battery left in a discharge status may cause degradation,
resulting in making the battery unavailable in emergency situations.
• Keep magnetic media, such as hard disks, away from the Drive Motor as the device contain magnets.
Cautions
Detection window of the ABD/Flow Sensor
To Next Page
Loading...
