Thermo Scientific QuantStudio 1 - Manage the Instrument Name (Administrator Only); Enable Sleep Mode; Set the Idling Temperature for the Heated Cover; Configure the Network Drive

1.
In the home screen, touch Seings4Instrument Seings4Instrument
Name.
2.
Touch the Instrument Name eld, enter an instrument name, then touch Done.
3.
(Optional) Touch Add Avatar to associate an avatar with the instrument.
Insert a USB drive with image les to use this option.
4.
Touch OK.
1.
In the home screen, touch
Seings4Instrument Seings4Sleep Mode.
2.
Slide the control On to enable sleep mode.
3.
Touch Edit Time, then enter the time length of inactivity before the instrument
enters sleep mode.
4.
Touch Enter, then touch OK.
1.
In the home screen, touch
Seings4Instrument Seings4Heated Cover
Idle Temperature.
2.
Slide the control On to set the idling temperature for the heated cover.
3.
Touch the Edit Temperature eld, then enter the desired idling temperature.
4.
Touch Enter, then touch OK.
1.
In the home screen, touch Seings4Instrument Seings4Network Drive.
Note: Contact a representative from your information technologies department
for the IP address.
2.
Enter a Drive Location.
3.
Enter a Domain Name, User Name, and Password, if required.
4.
Touch Connect.
This seing is required for API access to the instrument. When enabled, the desktop
software cannot connect to the instrument. Do not access unless instructed to do so by
a service representative.
Manage the
instrument name
(Administrator
only)
Enable Sleep
Mode
Set the idling
temperature for
the heated cover
Configure the
network drive
OEM connection
only
(Administrator
only)
Chapter 3 Configure the instrument and manage instrument profiles
Manage instrument settings
3
QuantStudio
™
1 Real-Time PCR System Installation, Use, and Maintenance Guide
31