Thermo Scientific QuantStudio 1 - Network Requirements

Network requirements
The instrument:
• Is factory-congured for IPv4 TCP/IP communication and includes an Ethernet
adapter (100/1,000 Mbps) with an RJ45-type connector for integrating the device
into a local area network (LAN).
• Can alternatively be congured for wireless networking (High Power USB WiFi
Module required, sold separately as an optional accessory).
The instrument can be congured for either wired or wireless networking, not both.
If a Thermo Fisher Scientic service representative is to install the instrument:
• If the instrument will be connected to a LAN, an active, tested network jack must
be in place before the scheduled installation date.
• A representative from your information technologies department must be
available during the installation to help connect the instrument to your network.
Required materials to network the instrument:
• Wired—Ethernet cable of sucient length with RJ45 connectors
– CAT5 cable for a 100 Mbps network connection
– CAT5e or CAT6 cable for a 1,000 Mbps network connection
–or–
• Wireless—High Power USB WiFi Module (Cat. No. A26774, sold separately)
Appendix C Instrument specification and layout
Network requirements
C
90
QuantStudio
™
1 Real-Time PCR System Installation, Use, and Maintenance Guide