Thermo Scientific QuantStudio 1 - Networking; Supported Options for Instrument and Computer Connections

5.
Select Internet Protocol (TCP/IP)4Properties.
6.
Set the Internet Protocol (TCP/IP) Properties for either DHCP or Static IP
communication:
Network
configuration
Action
DHCP
1. Select Obtain an IP address automatically.
2. Set the DNS address. If the computer obtains DNS
addresses:
• Automatically – Select Obtain DNS server address
automatically.
• Statically – Select Use the following DNS address,
then enter the address of the preferred and alternate
DNS servers (if available).
Static IP
1. Select Use the following IP address.
2. In the IP Address field, enter the static IP address.
3. If necessary, enter a subnet mask.
4. If necessary, enter a static gateway address in the Default
Gateway field.
7.
If your network requires advanced TCP/IP setup (such as WINS), dene the
seings:
a.
Click Advanced in the Internet Protocol (TCP/IP) Properties dialog box.
b.
Dene the IP Seings, DNS, and WINS tabs as instructed by your systems
administrator, then click OK.
8.
Close all dialog boxes by clicking OK, then re-start the computer.
The computer is now visible to other computers on the network.
Networking
IMPORTANT! This section provides general networking information. It does not
provide adequate detail to integrate the instrument into all possible network
architectures. Because a network may contain advanced features (such as a rewall or
network domains), we recommend that you consult a network administrator before
connecting the instrument to your laboratory network.
We support the following direct, networked (LAN– local area network), or Cloud
congurations. Congurations other than those listed are not recommended. Select a
conguration that meets the needs of your laboratory's instrument, software, and
workow requirements.
IMPORTANT!
Do not connect both an Ethernet cable and the Wi-Fi module
(Cat. No. A26774) to the instrument. Conguring the instrument for both wired and
wireless connection can interfere with instrument operation.
Supported options
for instrument
and computer
connections
Appendix A Install and connect the instrument to a network
Networking
A
QuantStudio
™
1 Real-Time PCR System Installation, Use, and Maintenance Guide
81