DK40 Universal Slot PCBs
PACU AC15 Tie Line Unit
3-20
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
PACU Programming
Program 03: Specify code 14 for slots that support PACUs and make sure the K5RCU is
enabled for DTMF operation.
Program 10-1: Enables/disables two-line conference.
Program 10-5: Assigns privacy on the tie line transferred calls.
Program 12: Assigns various timing operations to the PACU.
Program 15: Assigns tandem connection, exchange line signalling and recall.
Program16: Assigns the tie lines to line groups.
Program 17: Assigns immediate or wink start, camp on over tie lines, paging over tie lines.
Note
Also used to turn on the tie line dial tone return.
Program 30: Disables K5RCU for dial pulse operation.
Program 39: Assigns line access buttons to digital and electronic telephones.
Program 40: Assigns station access to tie lines (incoming & outgoing).
Program 41: Assigns station access to the lines (outgoing).
Program *43: Assigns outgoing digit translation.
Program *44: Assigns incoming digit translation.
Programs 50~56: Assigns LCR, if using the network as a route operation.
Program 93: Assigns a name to a tie line
To Next Page
Loading...
