Toshiba Strata DK40 - SMDR Programming; SMDR Printer;Call Accounting Device Installation

Peripheral Installation SMDR Printer/Call Accounting Device Options
6-42
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
SMDR Programming
Program 03
◆ The SMDR output is provided by the PIOU or PIOUS with the lowest code assigned (41
or 42).
Program 60
◆ Item 2: Selects the minimum duration (1.0 or 10 seconds) of calls that will be registered
by SMDR. Any call that lasts less than the set time will not be recorded.
◆ Item 3: Selects the records of outgoing calls or outgoing and incoming calls to be
printed.
◆ Item 4: Selects the digit length of Account Codes (4 to 15 digits).
◆ Item 5: Allows only long distance call records to be printed.
◆ Item 6: DISA security code.
◆ Item 9: Selects the recording of abandoned calls.
SMDR Printer/Call Accounting Device Installation
1. Connect the interface cable (TTY-PC-CABLE or PPTC1A-5M) from the PIOU,
PIOUS, SMDR port to the SMDR printer or call accounting device DB25 or DB9
connector. (See Figure 6-25 and related drawings in Chapter 4 – DK40 Universal Slot
PCB Wiring.)
2. Set the PIOU or PIOUS SW1 switch to the appropriate bps rate (300 or 1200 bps) as
determined by the baud rate of the printer or call accounting device.
3. Set the printer or call accounting device to no parity/8-bits/one stop bit.
4. Use Program 60 to set the system for the required SMDR printer/call accounting device
options (refer to the following section and the DK40 Strata Programming Manual).