Toshiba Strata DK40 - Table 3-14 RBSU;RBSS Option Switches, Jumpers, and Connectors

DK40 Universal Slot PCBs RBSU/RBSS ISDN Basic Rate Interface Unit
3-50
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
Table 3-14 RBSU/RBSS Option Switches, Jumpers, and Connectors
Circuit
Option
Switch
Type
Circuit Type
Description
TE NT
RBSU
All SW 1 Push button N/A N/A
Resets firmware on all circuits of
RBSU/RBSS. Drops calls off the
RBSU/RBSS.
1 SW 2 Jumper X X
Causes the circuit to operate as
TE or NT
1
.
1.
Also requires Program *60 to be set for TE or NT.
1SW 3Slide ONOFF
Switches a 100-ohm resistor in/
out of the circuit.
1
SW 4,
5
Jumper N/A ON
Switches PS-1 in/out of the circuit.
2 SW 6 Jumper X X
Causes the circuit to operate as
TE or NT
1
.
2SW 7Slide ONOFF
Switches a 100-ohm resistor in/
out of the circuit.
2
SW 8,
9
Jumper N/A ON
Switches PS-1 in/out of the circuit.
1J1
8-pin Modular
Connector RJ45
XX
Connects the RBSU Cct 1 to the
Network Provider Interface
2J2
8-pin Modular
Connector RJ45
XX
Connects the RBSU Cct 2 to the
Network Provider Interface
RBSS
3 (NT
only)
SW 1 Slide ON OFF
Switches a 100-ohm resistor in/
out of the circuit.
3 (NT
only)
SW 3,
4
Jumper N/A ON
Switches PS-1 in/out of the circuit.
4 (NT
only)
SW 2 Slide ON OFF
Switches a 100-ohm resistor in/
out of the circuit.
4 (NT
only)
SW 5,
6
Jumper N/A ON
Switches PS-1 in/out of the circuit.
1J6
8-pin Modular
Connector RJ45
XX
Connects the RBSS Cct 1 to the
Network Provider Interface
2J7
8-pin Modular
Connector RJ45
XX
Connects the RBSS Cct 2 to the
Network Provider Interface