Toshiba Strata DK40 - Programming Overview; RPTU Installation

DK40 Universal Slot PCBs RPTU ISDN Primary Rate Interface Unit
3-30
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
1
Allowed RPTU slots.
2
Slots must be vacant.
RPTU Installation
Before installing a RPTU PCB into a DK40, a number of system programs should be run.
This enables the RPTU to function immediately upon insertion. Refer to the DK 40
Programming Manual for more information.
Programming Overview
Program 03: Assign the RPTU PCB slot position (15 or 17), as type 76
Program *09: Assigns incoming digits to ring system groups (DDI Mode Only)
Program *10: Assigns incoming digits to ring ACD groups (DDI Mode Only)
Program *11: Assigns translation of Called Party Number (CPN) on incoming calls
Program 14-0: Assigns incoming ringing to ACD group (DEL mode only)
Program 16: Assigns the ISDN30 channels to line groups
Program 30: Allows standard telephone devices to dial ‘#’ to separate the dialled number and
the “Sub-Address”.
Program 39: Assigns line access buttons and a “Sub-Address” key for Digital or Electronic
key telephones.
Program 40: Assigns station access to lines (incoming and outgoing)
Program 41: Assigns station access to lines (outgoing only)
Program *42-1~2: Assigns the RPTU circuits as the primary & secondary timing source.
Programs 45~48: Defines Toll Restriction for any line.
Program *45: Assigns unused port numbers to have a translation number assigned that allows
calls to be routed to another number (e.g. home telephone number for Teleworking).
Programs 50~56: Defines Least Cost Routing assignments (incl. Program 55 which allows
“Sub-Address” information to be included in the modified digit string when calls are routed
via LCR).
Program *61-1: Allows a bearer service of “speech” or “3.1kHz” to be set for analogue
exchange line calls using ISDN30 channels for outgoing calls (e.g. DISA or Call Forward
External)
Program *61-1~3: Assigns a Bearer Service and Transmit and Receive levels for analogue to
digital trunk connections.
Program *62-1~3: Assigns a Bearer Service and Transmit and Receive levels for analogue
station to Digital trunk connections
Table 3-10 DK40 - RPTU Slot Assignments
RPTU
1
/Vacant Slots
2
DK40 Expansion Cabinet 15
1
/16
2
17
1
/18
2