Toshiba Strata DK40 - Carbon Headset;Handset Straps; Beep Strap

Station Apparatus Telephone Upgrades
5-14
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
9. For 2000-series digital telephones, see Figure 5-6 (DKT2010-FH) or Figure 5-7
(DKT2010-FS, DKT2010-FSD, DKT2020-FS, DKT2020-FSD), and locate the HHEU
strap on the PCB in the telephone. Cut the strap if a headset will be connected to the
HHEU.
Note
If the HHEU PCB is removed from the telephone, the HHEU strap must be replaced
for proper telephone operation.
10. Reinstall the telephone base, and secure it with its four captive screws.
➤ To adjust the volume of the HESB Loud Ringing Bell
1. Call the telephone connected to the HESB.
2. Adjust the volume control on the back of the HESB and the ring volume control on the
telephone.
Carbon Headset/Handset Straps
If a carbon-type handset or headset is connected to the handset jack on the side of the
telephone, two jumper straps inside the telephone must be cut.
➤ To cut the straps
Note
It is not necessary to cut these straps if the headset is connected to the HHEU.
1. Loosen the four captive screws securing the telephone base (Figure 5-1), and remove the
base.
2. For 2000-series digital telephones, see Figure 5-6 or 5-7, and cut the W201 and W202
carbon straps.
3. Reinstall the telephone base, and secure it with its four captive screws.
Note
The DKT2001-F will not support Carbon Headsets/Handsets.
Beep Strap
A “beep” sounds whenever a dial pad or feature button is pressed on a digital telephone.
➤ To eliminate the beep sound
1. Loosen the four captive screws securing the telephone base (Figure 5-1) and remove the
base.
2. For 2000-series digital telephones, see Figure 5-6 or 5-7, and cut the beep strap.
3. Reinstall the telephone base, and secure it with its four captive screws.