PEMU DC5 Tie Line Unit
DK40 Universal Slot PCBs
Strata DK40 I&M Manual Spring 1999
3-23
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
PEMU Programming
Program 03: Specify Code 13 for slots that support PEMUs and make sure K5RCU is
enabled for DTMF operation.
Program 10-1: Enables/disables two-line conference.
Program 10-5: Assigns privacy on Tie line transferred calls.
Program 12: Assigns various timing options to the Tie lines.
Program 15: Assigns tandem connections and dial pulse option to tie lines.
Program 16: Assigns Tie lines to line groups.
Program 17: Assigns immediate or wink start to PEMU tie lines.
Important!
Also used to turn on tie line dial tone return.
Note
When a PEMU is installed in a system, it automatically assumes the next four
consecutive Exchange line numbers.
Program 30: Disables K5RCU for dial pulse operation.
Program 39: Assigns line access buttons to digital and electronic telephones.
Program 40: Assigns station access to Tie lines (incoming and outgoing).
Program 41: Assigns station access to Tie lines (outgoing).
Program *43: Assigns outgoing digit translation.
Program *44: Assigns incoming digit translation.
Programs 50~56: Assigns LCR, if using the network as a route option.
Program 93: Assigns a name to a tie line
To Next Page
Loading...
