SMDR Printer/Call Accounting Device Options
Peripheral Installation
Strata DK40 I&M Manual Spring 1999
6-41
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
Example 3–DISA Outgoing Exchange Line Call
Note
DISA Exchange line calls print out as DISA.
Call Sequence C
◆ Outside caller rings Exchange line 001. (Line 001 is programmed as DISA.)
◆ Line 001 returns intercom dial tone after two ring cycles (5~6 seconds).
◆ Caller dials #7003 to access Exchange line 003 (outgoing).
◆ Caller dials the DISA security code and receives Exchange dial tone.
◆ Caller dials the telephone number and converses when the call is answered.
◆ Caller hangs up.
◆ The call releases, and Printout C prints after the call disconnects. Examples of both
call type scenarios are given (i.e. when the automatic release signal is received and
when the call is forced to clear using the disconnect timer set for 30 minutes in
Program 12-4).
Notes
◆ If the Exchange provides the Calling Party Control or Auto Release (AR) signal (see
Program 15 in the DK40 Programming Manual), the call disconnects when either party
hangs up. A “*” will follow the Exchange line number on the printout if the call is
disconnected by the CPC or AR signal.
◆ If the CPC or AR signal is not sent, the Exchange lines will remain seized until the DISA
disconnect timer releases the call (see Program 12 in the DK40 Programming Manual).
Printout C
Automatic Release signal:
001 MSS 12:20 00:00;08 00:05 DISA
001* DISA 12:22 00:02;01
003 DISA 12:22 00:02;01 01932833500
Disconnect Timer
001 MSS 12:20 00:00;08 00:05 DISA
001 DISA 12:52 00:30;57
003 DISA 12:52 00:30;57 01932833500
Note
The “MSS” entry prints out only if the call was connected after the SMDR
threshold, 1.0 or 10 seconds. The threshold is set in Program 60-2 (See DK40
Programming Manual).
To Next Page
Loading...
