External Page Options
Peripheral Installation
Strata DK40 I&M Manual Spring 1999
6-31
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
Zone Paging with BGM (Separate Amplifiers)
Provides multiple-zone paging capability. The output of the paging amplifier is routed back
to the PIOU, where it is switched to one of four sets of speakers by PIOU Relays K1 through
K4. The relay selected is determined by the access code dialled by the station user. Default
access codes are:
Note
Multi-zone page output rating is 30W/maximum at 300 ohms.
An all zone page code (&6<) is also available as an option (see Program 10-2 in the DK40
Programming Manual). When the All Page code is dialled, all four relays are activated to
permit simultaneous paging to all speaker zones and all digital and electronic telephone
speakers.
➤ To install the page and background music features on the same amplifier
1. Connect from the Paging Amplifier to the 600 ohm output on the Base Unit. (see
Figure 6-18).
2. Connect the BGM music source to the music amplifier input.
3. Connect the paging amplifier (+) output to each PGIN of the PIOU relays K1~K4 and
the amplifiers (-) output to each of the zone A~D speakers (C).
4. Connect the BGM music amplifier output to terminal 23 (PG COMMON) of the PIOU,
and the (-) to the (-) out of the page amplifier.
5. Connect the PIOU PGOUT pins to the zone A~zone D speakers (A).
PIOU Relay Access Codes DKT LCD Display
K1/zone 1 =
&68
External Paging A
K2/zone 2 =
&69
External Paging B
K3/zone 3 =
&6:
External Paging C
K4/zone 4 =
&6;
External Paging D
All zones =
&6<
EXT + ALL CALL PAGE
To Next Page
Loading...
