KSU Mounting Considerations
DK40 Installation
Strata DK40 I&M Manual Spring 1999
2-9
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
8. Swing the Expansion KSU away from the mounting surface, and drill a hole at the mark
made in Step 7.
9. Install the PCBs per “DK40 PCB Configuration” on Page 1-11 and slide the slot lock to
the lock position. See Figure 2-11.
10. Swing the Expansion KSU back to the mounting surface and secure it to the surface
with a screw.
11. Connect the wiring (e.g., modular line cords, CW1308 cable connections, 25-pair
amphenol connector–per Chapter 3–DK40 Universal Slot PCB Wiring) to the PCBs.
See Figure 2-8.
12. Fasten the wiring with tie wraps (supplied) to the bottom of the expansion and Base
KSUs.
13. Knock out the tab on the bottom of the side cover.
14. Plug the AC power cable into an outlet and then turn ON the power supply switch.
15. Install the side cover to the Expansion KSU. See Figure 2-11.
To Next Page
Loading...
