Toshiba TECRA 9100 Series - Sound Troubleshooting; Procedure 1 Diagnostic Test Program Execution Check; Procedure 2 Connector Check; Procedure 3 Replacement Check

2 Troubleshooting Procedures 2.15 Sound Troubleshooting
2-56 TECRA 9100 Maintenance Manual (960-347)
2.15 Sound Troubleshooting
This section describes how to determine if the computer's sound functions are functioning
properly. Perform the steps below starting with Procedure 1 and continuing with the other
procedures as required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check
Procedure 3: Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
The Sound/LAN/Modem test program is stored on the computer’s diagnostic disk. Insert the
Diagnostics disk in the computer's floppy disk drive, turn on the computer and run the test.
Refer to Chapter 3, Tests and Diagnostics, for details.
If an error is detected, go to Procedure 2.