4 Replacement Procedures 4.7 Wireless LAN Card
4-30 TECRA 9100 Maintenance Manual (960-347)
4.7 Wireless LAN Card
Removing the Wireless LAN Card
To remove the wireless LAN card (option), make sure the computer is in boot mode and
powered off, follow the steps below and refer to figures 4-18 and 4-19.
CAUTION: Do not try to remove the wireless LAN Card with the computer turned on.
You can damage the computer and the wireless LAN Card.
1. Remove one M2×4 flat-head screw.
2. Remove the wireless LAN card slot cover.
CAUTION: Do not touch the connectors on the wireless LAN Card module on the
computer. Debris on the connectors may cause wireless LAN Card access problems.
Metal plate
M2×3 flat-head screw
Figure 4-18 Removing the wireless LAN card slot cover
To Next Page
Loading...
