Toshiba TECRA 9100 Series - Removing the RTC Battery

4 Replacement Procedures 4.11 RTC Battery
TECRA 9100 Maintenance Manual (960-347) 4-44
Removing the RTC Battery
To remove the RTC battery, follow the steps below and refer to figure 4-27.
1. Disconnect the RTC battery cable from PJ5 on the I/O board.
2. Lift up the insulator covering the RTC battery.
3. Lift out the RTC battery.
PJ5
RTC battery
Figure 4-27 Removing the RTC battery