3.1 The Diagnostic Test 3 Tests and Diagnostics
TECRA 9100 Maintenance Manual (960-347) 3-1
3
3.1 The Diagnostic Test
This chapter explains how to use the Diagnostic Test program to test the functions of the
computer’s hardware modules. The Diagnostic Test Program is stored on the Diagnostic
Disk. The Diagnostic Test program consists of eight programs that are grouped into the
Service Program Module (DIAGNOSTIC TEST MENU).
NOTES: To start the diagnostics, follow these steps:
1. Check all cables for loose connections.
2. Exit any application you may be using and close Windows.
3. Do not turn on the computer in Windows 2000/XP before you insert the Diagnostics
disk in the floppy disk drive. The computer system will hang up. If you insert the
Diagnostic disk while the computer is running, shut down the computer, and reboot
from the Diagnostics disk.
The DIAGNOSTIC MENU consists of the following eight functions.
DIAGNOSTIC TEST
HEAD CLEANING
LOG UTILITIES
RUNNING TEST
FDD UTILITIES
SYSTEM CONFIGURATION
EXIT TO MS-DOS
SETUP
The DIAGNOSTIC TEST MENU contains the following fourteen functional tests:
SYSTEM TEST
MEMORY TEST
KEYBOARD TEST
DISPLAY TEST
FLOPPY DISK TEST
PRINTER TEST
ASYNC TEST
HARD DISK TEST
REAL TIMER TEST
NDP TEST
EXPANSION TEST
CD-ROM/DVD TEST
LAN TEST
To Next Page
Loading...
