4.19 Cooling Fan 4 Replacement Procedures
4-63 TECRA 9100 Maintenance Manual (960-347)
4.19 Cooling Fan
Removing the Cooling Fan
To remove the cooling fan, follow the steps below and refer to figures 4-39 and 4-40.
CAUTION: The cooling fan can become very hot during operation. Conduct repair
work after the fan has cooled. Do not touch or apply impact to the cooling fan.
1. Disconnect the battery cable from PJ202 on the system board.
2. Remove four M2×10 screws securing the cooling fan.
3. Remove the cooling fan.
M2×10 screws
Battery cable
Cooling fan
Figure 4-39 Removing the cooling fan
To Next Page
Loading...
