Toshiba TECRA 9100 Series - Connector Board; Removing the Connector Board

4.16 Connector Board 4 Replacement Procedures
4-57 TECRA 9100 Maintenance Manual (960-347)
4.16 Connector Board
Removing the Connector Board
To remove the connector board, follow the steps below and refer to figures 4-35 and 4-36.
1. Remove one M2.5×4 flat-head screw securing the connector board.
2. Lift up connector board in the direction of the arrow, to disconnect it from PJ104 on
the I/O board.
M2×4 flat-head screw
Connector board
M2.5×4 screw
Figure 4-35 Removing the connector board
3. Remove one M2.5×4 flat-head screw securing the connector board.
4. Unfasten the plastic brace and lift up the connector board.
M2.5×4 screw
Plastic brace
Connector board
Figure 4-36 Removing the connector board