Toshiba TECRA 9100 Series - Memory Modules (Option); Removing the Memory Module (Option)

4 Replacement Procedures 4.3 Memory Modules (Option)
4-18 TECRA 9100 Maintenance Manual (960-347)
4.3 Memory Modules (Option)
Removing the Memory Module (Option)
To remove the memory module (option) make sure the computer is in boot mode and
powered off, follow the steps below and refer to figures 4-9 and 4-10.
CAUTION: Do not try to remove a memory module with the computer turned on. You
can damage the computer and the memory.
1. Turn the computer upside down.
2. Remove two M2.5×3 silver flat-head screws.
3. Lift off the memory slot cover.
CAUTION: Do not touch the connectors on the memory module(s) or on the computer.
Debris on the connectors may cause memory access problems.
M2.5×3 silver flat-head screws
Memory slot cover
Figure 4-9 Removing the memory slot cover