4.5 Bluetooth Board 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-23
4.5 Bluetooth Board
Removing the Bluetooth Board
To remove the Bluetooth board (option), make sure the computer is in boot mode and
powered off, follow the steps below and refer to figures 4-12 and 4-13.
CAUTION: Do not try to remove the Bluetooth board with the computer turned on.
You can damage the computer and the Bluetooth board.
1. Turn the computer upside down.
2. Remove one M2×4 flat-head screw.
3. Remove the Bluetooth board cover.
CAUTION: Do not touch the connectors on the Bluetooth board or on the computer.
Debris on the connectors may cause Bluetooth board access problems.
M2×4 flat-head screw
Figure 4-12 Removing the Bluetooth board cover
To Next Page
Loading...
