4.21 Display Mask 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-69
4
4.21 Display Mask
Removing the Display Mask
To remove the display mask, follow the steps below and refer to figures 4-44 and 4-45:
1. Remove two mask seals at the bottom corners of the display assembly.
2. Remove two M2.5×6 flat-head screws.
NOTE: Support the display with your hand when you remove the screws.
M2.5×6 screws
Mask seals
Figure 4-44 Removing the screws on the display mask
To Next Page
Loading...
