Toshiba TECRA 9100 Series - Appendix J Connection for Check

Appendix J Connection for Check
TECRA 9100 Maintenance Manual (960-347) J-1
Appendix J
Appendix J Connection for Check
The following figure shows the connection for checking the circuit.
I/O Board
System Board
UL2012P29
Cable
FSZFT2
Connector cable
PJ19
PJ100
Figure J-1 Connection for the I/O Board and System Board
1. Connect cable UL2012P29 to the system board.
2. Lay the system board right side up.
3. Firmly connect one end of FSZFT2 to PJ19 on the I/O board.
4. Firmly connect the other end of the FSZFT2 to PJ100 on the system board.
CAUTION: Make sure you connect the boards securely. A loose connection could
damage the boards. Also, if the connectors are not fully seated the boards could be bent
and damaged.
CAUTION: Don not lay the system board flat. Make sure it leans against a stand when
you check the connection.