Toshiba TECRA 9100 Series - Wireless LAN Test Program

3. 27 Wireless LAN Test Program 3 Tests and Diagnostics
TECRA 9100 Maintenance Manual (960-347) 3-75
3.27 Wireless LAN Test Program
This section describes how to perform the wireless LAN transmitting-receiving test with the
test program.
Note:
Use another computer that can communicate by the wireless LAN as a reference
machine to perform this test.
To start the Wireless LAN test program, follow the steps below:
Insert a floppy disk containing the test program into the target machine and turn on the target
machine. The Wireless LAN test menu will appear.
##### TECRA9100 Wireless LAN sub system repair test VX.XX ########
.... Press test number[1-3,0] ?
############################################################################
****************************************************************************
* *
* 1 ............ Transmit & Receive test [Responder] *
*
* 2 ............ MAC Address test [Mini-PCI Wireless LAN] *
* 3 ............ Wireless LAN (WEP64/128) test *
* 0 ............ Transmit & Receive test [Initiator] *
* *
############################################################################
* *
Press 1, 2 or 3 key to perform the corresponding sub test. To quit the Wireless LAN test
program, eject the floppy disk and turn the computer off while the menu above is displayed.