Toshiba TECRA 9100 Series - System Test

3.5 Memory Test 3 Tests and Diagnostics
TECRA 9100 Maintenance Manual (960-347) 3-9
3.4 System Test
To execute the System Test select 1 from the DIAGNOSTIC TEST MENU, press Enter and
follow the directions on the screen. Move the highlight bar to the subtest you want to execute
and press Enter.
Subtest 01 ROM Checksum
This subtest executes a checksum test of the BIOS ROM on the System
Board.
Subtest 04 Fan On/Off
This subtest checks fan operation using the on/off command.
*** Fan ON *** : Press [Enter] key?
When you press Enter, the fan should spin.
*** Fan OFF *** : Press [Enter] key?
When you press Enter, the fan should stop.
Subtest 05 Geyserville
If the CPU supports Geyserville (SpeedStep), this Subtest checks that the
CPU operating clock speed can be changed.
Subtest 06 Charge
Displays charge status.
Subtest 07 DMI read
Reads the factory setting for the serial and DMI numbers.
Model Name : XXXXXX
Version Number : XXXXXX-XXXXX
Serial Number : XXXXXX
Model Number : XXXXXX
PCN/BND Number : XXXXXX
UUID Number : XXXXXX
Subtest 08 DMI write
Write to memory the factory setting for serial and DMI numbers, input from
the keyboard.