3 Tests and Diagnostics 3.14 Expansion Test
3-32 TECRA 9100 Maintenance Manual (960-347)
3.14 Expansion Test
To execute the expansion test, select 11 from the DIAGNOSTICS TEST MENU, press
Enter and follow the directions on the screen. The expansion test contains one subtest.
NOTE: To execute this subtest, the PC card wraparound connector is required.
Subtest 01 PCMCIA Wraparound
This test checks the following signal line of the PC card slot:
Address line
REG#, CE#1, CE#2 line
Data line
Speaker line
Wait line
BSY#, BVD1 line
This subtest is executed in the following order:
Sub# Address Good Bad Contents
01 00001
00001
nn
nn
xx
xx
Address line
REG#, CE#1, CE#2
nn=A0, 90, 80, 00
02 00002 ww rr Data line
ww=write data, rr=read
data
03 00003 –– –– Speaker line
04 00004 40,80 xx Wait line (40<xx<80)
05 00005 nn xx Other lines (BSY#, BVD1)
NN=21, 00
NOTE : Select the subtest number01 The following message will apper:Test slot number
select (1:slot, 2:slot, 0:slot0&1)?
NOTE : Subtests 02, 04 and 05 are for Advanced Port Replicator 2001. For procedures
on those subtests, refer to the Advanced Port Replicator 2001 maintenance manual.
To Next Page
Loading...
