EasyManuals Logo

Toshiba TECRA 9100 Series User Manual

Toshiba TECRA 9100 Series
428 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #89 background imageLoading...
Page #89 background image
2.10 COMBO Drive Troubleshooting 2 Troubleshooting Procedures
TECRA 9100 Maintenance Manual (960-347) 2-43
2.10 COMBO Drive Troubleshooting
This section describes how to determine if the CD-ROM/DVD-ROM/COMBO drive in the
Slim Select Bay is functioning properly. Perform the steps below starting with Procedure 1
and continue with the other procedures as required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
The CD-ROM/DVD-ROM test program is stored in the Diagnostics Disk.
For the test, prepare a test DVD-ROM and CD-RW Media (branch).
Then insert the Diagnostics Disk in the computer’s floppy disk drive, turn on the computer
and run the test. Refer to Chapter 3, Tests and Diagnostics, for more information about the
diagnostics test procedures.
If any errors occur while executing the CD-ROM/DVD-ROM test, go to Procedure 2.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba TECRA 9100 Series and is the answer not in the manual?

Toshiba TECRA 9100 Series Specifications

General IconGeneral
CPUIntel Pentium III
Display14.1" TFT
Display Resolution1024 x 768
Optical DriveCD-ROM or DVD-ROM
Operating SystemWindows 2000 or Windows XP

Related product manuals