Toshiba TECRA 9100 Series - IEEE1394 Test Program

3.26 IEEE1394 Test Program 3 Tests and Diagnostics
TECRA 9100 Maintenance Manual (960-347) 3-73
3.26 IEEE1394 Test Program
This section describes how to perform the IEEE1394 test with the test program.
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
(a) Insert the Diagnostics disk in the floppy disk drive and turn on the computer.
(The Diagnostics Disk contains the MS-DOS boot files.)
The following menu shown in figure 3-1 will appear:
* IEEE1394 [TSB12LV28] test menu ( For Repair ) V1.00 *
Select [ 1 - 3 ] ?
*********************************************************************
*********************************************************************
* *
* 1 : ... IEEE1394 test *
* 2 : ... Responder tool *
* 3 : ... ID Check *
* *
* --------------------------------------------------------- *
* --------------------------------------------------------- *
* ============ Select test NO. and [Enter] ============ *
* *
Figure 3-1
(b) To execute the TEST, select the option number you want to execute and press Enter.