4.1 General 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-11
Removing the Optional PC Card
To remove the PC Card (option), make sure the computer is in boot mode, then follow the
steps below and refer to figure 4-3.
CAUTION: Before you remove a PC Card, refer to the card's documentation and to your
operating system documentation for proper procedures and precautions.
1. When the security lock for the PC card is set, turn the computer upside down,
remove one silver M2.5×4 screw, slide the latch to the left to release the lock and
secure the M2.5×4 screw.
2. Turn the computer right side up.
3. Press the eject button for the PC card you want to remove to extend the button.
4. Press the extended eject button to pop the PC card out slightly.
5. Grasp the PC Card and pull it out.
PC Card
Eject button
Figure 4-3 Removing a PC Card
To Next Page
Loading...
