4.9 Modem Daughter Card 4 Replacement Procedures
4-39 TECRA 9100 Maintenance Manual (960-347)
Installing the Modem Daughter Card
To install the modem daughter card, follow the steps below and refer to figure 4-24.
1. Seat the modem daughter card and press carefully on the right end of the card to
connect it to PJ125 on the I/O board. Be careful not to damage the card or
connector.
2. Secure the modem daughter card with two M2×4 screws.
3. Connect the cable to PJ126 on the I/O board.
4. Secure the modem cable with the tape.
To Next Page
Loading...
