Toshiba TECRA 9100 Series - LED Board; Removing the LED Board

4.14 LED Board 4 Replacement Procedures
4-53 TECRA 9100 Maintenance Manual (960-347)
4.14 LED Board
Removing the LED Board
To remove the LED board, follow the steps below and refer to figure 4-33.
1. Remove two M2×4 screws and one M2×8 screw securing the LED board.
2. Carefully lift up the LED board to disconnect it from PJ105 on the I/O board.
M2.5×4 screws
PJ105
LED board
Figure 4-33 Removing the LED board