4.1 General 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-13
Removing the Optional SD Card
To remove the SD Card (option), make sure the computer is in boot mode, then follow the
steps below and refer to figure 4-4.
CAUTION: Before you remove an SD Card, refer to the card's documentation and to
your operating system documentation for proper procedures and precautions.
1. Turn the computer right side up.
2. Push the SD card in and release it to pop the card out slightly.
3. Grasp the SD card and pull it out.
SD Card
Figure 4-4 Removing a SD Card
Installing the Optional SD Card
To install the SD Card (option), follow the steps below and refer to figure 4-4.
1. Insert an SD Card.
2. Push it carefully to ensure a firm connection.
To Next Page
Loading...
