3 Tests and Diagnostics 3.20 Log Utilities
3-42 TECRA 9100 Maintenance Manual (960-347)
3.20 Log Utilities
3.20.1 Function Description
This function logs error information generated while a test is in progress and stores the
results in RAM. This function can store data on a floppy disk or output the data to a printer.
If the power switch is turned off, the error information will be lost. The error information is
displayed in the following order:
1. Error count (CNT)
2. Test name (TS-NAME)
3. Subtest number (TS-NAME)
4. Pass count (PASS)
5. Error status (STS)
6. FDD/HDD or memory address (ADDR)
7. Write data (WD)
8. Read data (RD)
9. HDC status (HSTS)
10. Error status name (ERROR STATUS NAME)
3.20.2 Operations
Selecting 5 and pressing Enter in the DIAGNOSTIC MENU, logs error information into
RAM or onto a floppy disk. The error information is displayed in the following format:
XXXXX ERRORS
CNT TS-NO PASS STS ADDR WD RD HSTS [ERROR STATUS NAME]
001 FDD 02 0000 103 00001 00 00 0000 FDD-WRITE PROTECTED
001 FDD 01 0000 180 00001 00 00 0000 FDD-TIME OUT ERROR
[[1:Next,2:Prev,3:Exit,4:Clear,5:Print,6:FD Log Read,7:FD Log Write]]
Error status name
Error count
Pass count
Error status
Subtest number
Address
Test name
Read data
Write data
HDC status
To Next Page
Loading...
