Toshiba TECRA 9100 Series - LCD Module; Removing the LCD Module

4 Replacement Procedures 4.23 LCD Module
4-74 TECRA 9100 Maintenance Manual (960-347)
4.23 LCD Module
NOTE: Be careful not to apply pressure to the ICs along the edge of LCD module. The
ICs are easily damaged.
NOTE: For environmental reasons, do not throw away a malfunctioning LCD module
(or FL). Please follow local ordinances or regulations for its disposal.
Removing the LCD Module
To remove the LCD Module, follow the steps below and refer to figures 4-47 to 4-49:
1. Remove four masking seals that cover the screws.
2. Remove four M2×4 screws that fasten the LCD module.
M2×4 screws
Masking tapes
M2×4 screws
Masking tapes
Figure 4-47 Removing four screws that secure the LCD module