3 Tests and Diagnostics 3.24 SET UP
3-56 TECRA 9100 Maintenance Manual (960-347)
NOTE:
1. Panel Power On/Off item appears only when the Power-up Mode is in Resume
mode.
2. Processor Serial Number item does not appear in the following case:
(1) A supervisor password and user password are registered.
(2) USER PASSWORD MODE = Unable to show Processor Serial Number item,
and
(3) A user password is used to log onto the computer.
3. The USB FDD Legacy Emulation item appears under the LEGACY EMULATION
item only when Floppy Disk I/O is set to Disabled.
4. The LCD Display Stretch item appears under the Display item only when the LCD
screen resolution is XGA (1024
×
768 LCD).
To Next Page
Loading...
