4.26 FL (Model 14.1 XGA Toshiba) 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-93
12. Separate the PCB-ASSY cell from the backlight unit. (1)
13. Remove entirely the remaining tape on the back of the cell and on the frame. (2)
14. Apply one strip of double-faced tape to the frame. (3)
NOTE: The top side of the cell (2) is attached to the frame with double-faced tape, so be
careful when you remove the cell.
Do not lift up the opaque tape on the top side of the cell.
Do not apply double-faced tape to the surface of the FL.
1
2
3
Double-faced tape
PCB-ASSY cell
Backlight unit
Figure 4-63 Separating the PCB-ASSY cell
To Next Page
Loading...
