4 Replacement Procedures 4.26 FL (Model 14.1 XGA Toshiba)
4-100 TECRA 9100 Maintenance Manual (960-347)
16. Apply the X insulation sheet (1) and the Y insulation sheet. (2)
17. Apply one strip of insulation tape "1" to the center of the left side. (3)
18. Apply one strip of insulation tape "1" to the center of the bottom side (FL side). (4)
19. Apply two strips of insulation tape "2" to the bottom side (FL side). (5)
20. Apply one strip of insulation tape "3" to secure the FL. (6)
NOTE: Do not damage the X-PCB, Y-PCB when you apply the tape or sheet.
2 1
2
Apply the X insulation sheet.
Do not bend.
Align with the edge of the module.
Apply the Y insulation sheet.
Do not bend.
Align with the edge of the module.
Align with the edge of the module.
Press the tape gently to avoid damaging the module.
1
1
Figure 4-69 Applying the insulation sheets and tapes
To Next Page
Loading...
