Toshiba TECRA 9100 Series - Page 320

4 Replacement Procedures 4.27 FL (Model 14.1 XGA Sharp)
4-108 TECRA 9100 Maintenance Manual (960-347)
15. Check as shown below after assembling.
Pin is aligned
with hole.
Pin is aligned
with hole.
Cover is
applied properly.
Cover is applied properly.
Screw is secure.
Screw is secure.
No damage.
No deformation.
Tape is applied properly.
Latch is secure.
Latch is secure.
Tape is applied properly.
Screw is secure.
Screw is secure.
Pin is aligned
with hole.
Pin is aligned
with hole.
Pin is aligned
with hole.
Figure 4-79 Checking the LCD module