4 Replacement Procedures 4.28 FL (Model 14.1 SXGA+ Sharp)
4-116 TECRA 9100 Maintenance Manual (960-347)
15. Check as shown below after assembling.
Screw is secure.
Screw is secure.
Screw is secure.
Screw is secure.
Pin is aligned
with hole.
Cover is
applied properly.
Pin is aligned
with hole.
Pin is aligned
with hole.
Pin is aligned
with hole.
Tape is applied properly.
Latch is secure.
Tape is applied properly.
Latch is secure.
No damage.
No deformation.
Figure 4-89 Checking the LCD module
To Next Page
Loading...
