TP-Link T1500 Series User Manual

Configuration Guide 200
Configuring GVRP GVRP Configuration
LeaveAll Timer
(centisecond)
When a GARP participant is enabled, the LeaveAll timer will be started. When
the LeaveAll timer expires, the GARP participant will send LeaveAll messages to
request other GARP participants to re-register all its attributes. After that, the
participant restarts the LeaveAll timer.
The timer ranges from 1000 to 30000 centiseconds and should be an integral
multiple of 5. The default value is 1000 centiseconds.
Join Timer
(centisecond)
Join timer controls the sending of Join messages. A GVRP participant starts the
Join timer after sending the first Join message. If the participant does not receive
any response, it will send the second Join message when the Join timer expires
to ensures that the Join message can be sent to other participants.
The timer ranges from 20 to 1000 centiseconds and should be an integral
multiple of 5. The default value is 20 centiseconds.
Leave Timer
(centisecond)
The Leave timer controls attribute deregistration. A participant will send a Leave
message if it wants other participants to deregister some of its attributes. The
participant receiving the message starts the Leave timer. If the participant does
not receive any Join message of the corresponding attribute before the Leave
timer expires, the participant deregisters the attribute.
The timer ranges from 60 to 3000 centiseconds and should be an integral
multiple of 5. The default value is 60 centiseconds.
LAG Displays the LAG the port is in.
3) Click Apply.
Note:
•
The member port of an LAG follows the configuration of the LAG and not its own. The
configurations of the port can take effect only after it leaves the LAG.
•
The egress rule of the ports dynamically added to the VLAN is tagged.
•
The egress rule of the fixed port should be tagged.
•
When setting the timer values, make sure the values are within the required range. The
configuration value for LeaveAll should be greater than or equal to ten times the Leave value.
The value for Leave should be greater than or equal to two times the Join value.
2.2 Using the CLI
Step 1 configure
Enter global configuration mode.
Step 2 gvrp
Enable GVRP globally.

TP-Link T1500 Series Specifications

General

Brand	TP-Link
Model	T1500 Series
Category	Switch
Language	English