Configuration Guide 750
Configuring SNMP & RMON SNMP Configurations
Security Level Set the security level. The security level from highest to lowest is: NoAuthNoPriv,
AuthNoPriv, AuthPriv, and the default is NoAuthNoPriv. The security level of the
user should not be lower than the group it belongs to.
NoAuthNoPriv: Uses a username match for authentication, and no encryption is
implemented.
AuthNoPriv: An authentication mode is applied to check packets, but no privacy
mode is applied to encrypt them.
AuthPriv: An authentication mode and a privacy mode are applied to check and
encrypt packets.
2) If you have chosen AuthNoPriv or AuthPriv as the security level, you need to set
corresponding Authentication Mode or Privacy Mode. If not, skip the step.
Authentication
Mode
With AuthNoPriv or AuthPriv selected, configure the authentication mode and
password. Two authentication modes are provided:
MD5: Enable the HMAC-MD5 algorithm for authentication.
SHA: Enable the SHA (Secure Hash Algorithm) algorithm for authentication. SHA
algorithm is securer than MD5 algorithm.
Authentication
Password
Set the password for authentication.
Privacy Mode With AuthPriv selected, configure the privacy mode and password for encryption.
The switch uses the DES (Data Encryption Standard) algorithm for encryption.
Privacy Password Set the password for encryption.
3) Click Create.
2.2 Using the CLI
2.2.1 Enabling SNMP
Step 1 configure
Enter global configuration mode.
Step 2 snmp-server
Enabling SNMP.
To Next Page
Loading...
Need help?
General