TP-Link T1500 Series - 2. DHCPv4 Filter Configuration

Configuration Guide 662
Configuring IPv6 IMPB ND Detection Configuration
3
ND Detection Configuration
To complete ND Detection configuration, follow these steps:
1) Add IPv6-MAC Binding entries.
2) Enable ND Detection.
3) Configure ND Detection on ports.
4) View ND statistics.
3.1 Using the GUI
3.1.1 Adding IPv6-MAC Binding Entries
The ND Detection feature allows the switch to detect the ND packets based on the
binding entries in the IPv6-MAC Binding Table and filter out the illegal ND packets. Before
configuring ND Detection, complete IPv6-MAC Binding configuration. For details, refer to
IPv6-MAC Binding Configuration
.
3.1.2 Enabling ND Detection
Choose the menu SECURITY > IPv6 IMPB > ND Detection > Global Config to load the
following page.
Figure 3-1 ND Detection Global Config
Follow these steps to enable ND Detection:
1) In the Global Config section, enable ND Detection and configure the related
parameters. Click Apply.
ND Detection Enable or disable ND Detection globally.