TP-Link T1500 Series - Configuring the System IPv6

Configuration Guide 30
Managing System System Info Configurations
IP Address Mode Specify the IP address assignment mode of the interface.
Static: Assign an IP address to the management interface.
DHCP: Assign an IP address to the management interface through the DHCP
server.
BOOTP: Assign an IP address to the management interface through the BOOTP
server.
DHCP Option 12 If you select the IP Address Mode as DHCP, configure the Option 12 here.
DHCP Option 12 is used to specify the client’s name.
IP Address Specify the IP address of the management interface if you select the IP Address
Mode as Static.
Subnet Mask Specify the subnet mask of the management interface if you select the IP
Address Mode as Static.
Default Gateway Specify the default gateway of the management interface if you select the IP
Address Mode as Static. The default gateway is the IP address to which the
packet should be sent next.
2) Click Apply.
2.1.6 Configuring the System IPv6
Choose the menu SYSTEM > System Info > System IPv6 to load the following page.
Figure 2-9 Configuring the System IPv6 Parameters
1) In the System IPv6 Config section, enable IPv6 feature for the interface and configure
the corresponding parameters . Then click Apply.