Configuring SNMP & RMON SNMP Configurations
Configuration Guide
747
Figure 2-3 Creating an SNMP View
View Name Set the view name with 1 to 16 characters. A complete view consists of all MIB
objects that have the same view name.
View Type Set the view to include or exclude the related MIB object. By default, it is include.
Include: The NMS can view or manage the function indicated by the object.
Exclude: The NMS cannot view or manage the function indicated by the object.
MIB Object ID Enter a MIB Object ID to specify a specific function of the device. When a MIB Object
ID is specified, all its child Object IDs are specified. For specific ID rules, refer to the
device related MIBs.
2) Click Create.
2.1.3 Creating SNMP Communities (For SNMP v1/v2c)
Choose the menu MAINTENANCE > SNMP > SNMP v1/v2c and click
to load the
following page.
Figure 2-4 Creating an SNMP Community
1) Set the community name, access rights and the related view.
Community Name Configure the community name. This community name is used like a password to
give the NMS access to MIB objects in the switch’s SNMP agent.
Access Mode Specify the access right to the related view. The default is read-only.
Read Only: The NMS can view but not modify parameters of the specified view.
Read & Write: The NMS can view and modify parameters of the specified view.
To Next Page
Loading...
