Configuring Access Security Access Security Configurations
Configuration Guide
491
2
Access Security Configurations
With access security configurations, you can:

Configure the Access Control feature

Configure the HTTP feature

Configure the HTTPS feature

Configure the SSH feature

Configure the Telnet function
2.1 Using the GUI
2.1.1 Configuring the Access Control Feature
Choose the menu SECURITY > Access Security > Access Control to load the following
page.
Figure 2-1 Configuring the Access Control
1) In the Global Config section, enable Access Control, select one control mode and click
Apply.
Control Mode Select the control mode for users to log in to the web management page.
IP-based: Only the users within the IP-range you set here are allowed to access
the switch.
MAC-based: Only the users with the MAC address you set here are allowed to
access the switch.
Port-based: Only the users connecting to the ports you set here are allowed to
access the switch.
To Next Page
Loading...
Need help?
General